picoDetector : How to detect metal with a PIC
Includes :mikroC PRO project files for PIC12F683, should work also with most of PIC
picoDetector C source code
picoDetector .HEX files
picoDetector circuit schematic
/*
***************************************************************
****************
* picoDetector : an ultra simple and cheap metal detector
***************************************************************
****************
*
*
*
*
* source code for mikroC PRO compiler V1.65
* feel free to use this code at your own risks
*
* target : PIC12, oscillator in HS mode, watchdog enabled
*
* PIC PIN Assignemnt :
*
* GP0 : detect LED indicator
* GP1 : calibrate LED indicator
* GP2 : NC
* GP3 : NC
* GP4, GP5 : inductor
*
***************************************************************
****************
*/
#define MAXTRY 15 // number of watchdog restart to calibrate loop counter
unsigned char ctr ; // number of loops between two watchdog resets
unsigned char previous ; // previous value of ctr
unsigned char calibr ; // calibration value when oscillator runs free
unsigned char restarts ; // number of watchdog restarts
unsigned char en ; // enable flag, allows detection
/*
* main loop
*/
void main()
{
unsigned char i ;
/*
* configure GPIO as digital port
*/
CMCON0 = 7 ;
ANSEL = 0 ;
TRISIO = 0 ;
GPIO = 0 ;
/*
* power up ?
*/
if(STATUS.NOT_TO)
{
/*
* yes, init variables
*/
restarts = 0 ;
calibr = 1 ;
}
/*
* watchdog reset counter
*/
if(restarts < 255) restarts++ ;
/*
* if counter differs too much from calibration value
*/
if((previous ^ ctr) > calibr)
{
/*
* turn detect LED on
*/
GPIO.F0 = en ;
/*
* if not on power up
*/
if(STATUS.NOT_TO == 0)
{
/*
* while in calibration mode
*/
if(restarts < MAXTRY)
{
/*
* shift calibration value
* and wait a little bit
*/
calibr <<= 1 ;
Delay_ms(5) ;
}
}
else
{
/*
* turn detect LED off
*/
GPIO.F0 = 0 ;
}
}
/*
* save last counter
*/
previous = ctr ;
/*
* is calibration over ?
*/
if(restarts > MAXTRY)
{
/*
* yes, turn calibrate LED off
* and set enable flag
*/
GPIO.F1 = 0 ;
en = 1 ;
}
else
{
/*
* no, turn calibrate LED on
* and clear enable flag
*/
GPIO.F1 = 1 ;
en = 0 ;
}
/*
* set watchdog prescaler
*/
OPTION_REG = 0b11111001 ;
/*
* start counter, to be interrupted by watchdog
*/
ctr = 0 ;
for(;;)
{
ctr++ ;
}
}
页:
[1]