英锐恩单片机论坛,Microchip单片机,模拟器件,接口电路,麦肯单片机,单片机应用交流

标题: 如果是接收串口发送过来的数据，一定也要用串口吗 [打印本页]

作者: winnie 时间: 2009-3-16 14:35
标题: 如果是接收串口发送过来的数据，一定也要用串口吗
还是可以用普通I/O口模拟串口

作者: winnie 时间: 2009-3-16 14:35
用普通I/O口模拟串口，CCS 讓你一分鐘搞定

  #include <16F877.H> // <18F452.H> // device header file from CCS-C

#use    delay(clock=20000000)    // 20 MHz crystal oscillator

#use    rs232(baud= 4800, xmit=PIN_B6, rcv=PIN_B7, stream=ICP)
#use    rs232(baud= 9600, xmit=PIN_B1, rcv=PIN_B2, stream=GPS)
#use    rs232(baud= 1200, xmit=PIN_C6, rcv=PIN_C7)

void main()
{
int8  x = 34;

while(1)
{
   putc( fgetc(GPS) );

   printf("x= %d ", x);

   fprintf(ICP, "x= %d ", x);

   delay_ms(1000);
}
}

作者: winnie 时间: 2009-3-16 14:36
用普通I/O口模拟 I2C ， CCS 讓你半分鐘搞定
#USE I2C

Syntax:
#use i2c (options)

Elements:
Options are separated by commas and may be:

MASTER
Set the master mode

SLAVE
Set the slave mode

SCL=pin
Specifies the SCL pin (pin is a bit  address)

SDA=pin
Specifies the SDA pin

ADDRESS=nn
Specifies the slave mode  address

FAST
Use the fast I2C specification

SLOW
Use the slow I2C specification

RESTART_WDT
Restart the WDT while waiting in I2C_READ

FORCE_HW
Use hardware I2C functions.

Purpose:
The I2C library contains functions to implement an I2C bus. The #USE I2C remains in effect for the I2C_START, I2C_STOP, I2C_READ, I2C_WRITE and I2C_POLL functions until another USE I2C is encountered.  Software functions are generated unless the FORCE_HW is specified.  The SLAVE mode should only be used with the built-in SSP.

Examples:
#use I2C(master, sda=PIN_B0, scl=PIN_B1)

#use I2C(slave,sda=PIN_C4,scl=PIN_C3

            address=0xa0,FORCE_HW)

Example Files:
ex_extee.c with 2464.c

Also See:
i2c_read(), i2c_write()

欢迎光临英锐恩单片机论坛,Microchip单片机,模拟器件,接口电路,麦肯单片机,单片机应用交流 (http://enroobbs.com/)